The Source of Inspiration.
DesignerVeneer is a specially selected colour palette, of 13 reconstituted veneers, drawing inspiration from the Australian Outback.
|Sizes:||3000 x 1200mm (Nominal)|
|Brochure:||DesignerVeneer Flyer PDF|
The Natural Beauty of Timber
The DesignerVeneer range from reconstituted timber veneers offers a decorative veneer board using timber in its most economical and environmentally sustainable form. All DesignerVeneer veneers are reconstructed from a range of timber species sourced from responsibly managed forests and are FSC® certified.
Ideal for use as doors, partitions and other vertical surfaces, the DesignerVeneer range is suitable for both residential and commercial applications.
DesignerVeneer uses an E0 MDF substrate. E0 is a low formaldehyde emitting product which has a formaldehyde emission of less than 0.5mg/L, which is lower than the current Australian standard LPM board.
DesignerVeneer is available with a prefinished surface reducing onsite installation time, or with a natural timber surface for your preferred finishing product.
DesignerVeneer is manufactured using superior dyes that are resistant to UV rays.
Just as natural timber veneers will tend to change colour in the presence of light, DesignerVeneer may also be affected. This is part of a natural process and not a defect in the veneers.
A UV coating is recommended to help minimise colour changes over time.
Keeping up Appearances
Just like other dyed products such as fabric, it is possible that DesignerVeneer colours may vary slightly from batch to batch between 5-10%.
To ensure the best results, all veneer for a project should be ordered at the same time and the same coating and processing systems used, if required.
Matching edging is available for all colours in rolls of 50LM x 22mm unglued unfinished raw veneer or ABS Prefinished Edging in Crossband and Longband for grain continuity.
- You cannot add "Saltbush" to the basket because the product is out of stock.